How to glue wallpaper at the corners: instructions, gluing outer, inner corner, docking
Step by step instructions for gluing inner corners
After finishing, the major problem can be uneven walls and the consequent folds on the background. It’s also required to take into account that as soon as the walls are twisted , the joints of background canvases can invisibly.
After gluing the previous one in front of the inner corner of the fabric must measure the remaining distance. It is measured from the border of the glued cloth to the adjacent wall, the resulting figure is inserted 10-15 millimeters. If the walls are extremely curved, the further figure could be more.
Cut a strip equal to the resulting figure, taking into consideration the allowance. The surfaces are treated with glue. Based on the type of coating it might be just the wall or surfaces.
The strip is glued independently using the cut side into the wallsocket. The background should go on the other plane.
If the glued wallpaper is sterile, then you will need to make a few smaller cuts perpendicular to the folds.
Level or incline on the adjoining wall is a perpendicular lineup. The distance in the corner is equal to the diameter of the prior cut strip, not such as additions.
The surfaces have been smeared with glue, and then the coating is glued into the wall using the flat side towards the line. The cut side goes onto the adjacent wall.
Protruding corner ought to be glued by analogy with an interior, but there are little gaps, which also need to be taken into consideration when working.
Measured the distance remaining in the glued background to the adjacent wall. Add 20-25 millimeters to the captured figure.
A section is cut away, considering the additional 20-25 millimeters.
Prior to gluing, the surfaces have been treated with gidpola.ru adhesive.
The edge has to be glued to the background fixed onto the wall, the own cut «extends» to the adjacent plane. If needed, small cuts are made in the place of going to another background, smoothed and pressed into the wallsocket.
Draw a vertical strip onto the adjoining wall at a distance of only glued cut strip plus 6-10 millimeters.
After applying the adhesive, the strip is placed on the wall with its flat side to the marked line, going over the border of the already glued strip.
The joints have been smeared with adhesive and ironed with a rollercoaster. Following that, the top layer is cut across the ruler and the 2 layers are joined together.
Рекомендуем также ознакомиться с разделами: